INSTALLER / CONSUMER
SAFETY INFORMATION
Wilshire
Freestanding Electric
Stove
PLEASE READ THIS MANUAL
BEFORE INSTALLING AND
USING APPLIANCE
Model: HES60
WARNING!
IF THE INFORMATION IN THIS
MANUAL IS NOT FOLLOWED
EXACTLY, AN ELECTRICAL SHOCK
OR FIRE MAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL
INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY
Service must be performed by a
qualified service agency.
DO NOT STORE OR USE
GASOLINE OR OTHER
FLAMMABLE VAPORS OR
LIQUIDS IN THE VICINITY OF
THIS OR ANY OTHER
APPLIANCE.
Installation Instructions and
Homeowners Manual
C
US
INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER
10006943 3/06 Rev. 3
IMPORTANT INSTRUCTIONS
Installation Instructions
General
1. Read all instructions before using this appliance.
14.Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause
an electric shock, fire or damage the appliance.
2. This appliance is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. If provided,
use handles when moving this appliance. Keep
combustible materials, such as furniture, pillows,
bedding, papers, clothes and curtains at least 3
feet (914mm) from the front of this appliance.
15.To prevent possible fire, do not block air intakes or
exhaust in any manner. Do not use on soft sur-
faces, like a bed, where openings may become
blocked.
3. CAUTION: Extreme caution is necessary when
any heater is used by or near children or
invalids and whenever the heater is left operat-
ing unattended.
16.This appliance has hot and arcing or sparking parts
inside. Do not use it in areas where gasoline, paint
or flammable liquids are used or stored. This appli-
ance should not be used as a drying rack for cloth-
ing, nor should Christmas stockings or decorations
be hung on or near it.
4. If possible always unplug this appliance when not
in use.
17.Use this appliance only as described in this manu-
al. Any other use not recommended by the manu-
facturer may cause fire, electric shock or injury to
persons.
5. Do not operate any heater with a damaged cord or
plug or after the appliance malfunctions, has been
dropped or damaged in any manner.
6. Any repairs to this appliance should be carried out
by a qualified service person.
18.Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of
fire. However, if you have to use an extension cord,
the cord shall be No. 14 AWG minimum size and
rated not less than 1875 Watts. The extension cord
must be a three wire cord with grounding type plug
and cord connector. The extension cord shall not
be more than 20 feet (6m) in length.
7. Under no circumstances should this appliance be
modified. Parts having to be removed for servicing
must be replaced prior to operating this stove
again.
8. Do not use outdoors.
9. This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. Never
locate this appliance where it may fall into a bath-
tub or other water container.
Locating Your Stove
10.Do not run cord under carpeting. Do not cover cord
with throw rugs, runners or the like. Arrange cord
away from traffic areas and where it will not be
tripped over.
Your new freestanding electric stove may be installed
virtually anywhere in your home. However, when
choosing a location for your new stove, ensure that
the general instructions are followed. Also, for best
effect, install the stove away from direct sunlight.
11.To disconnect this appliance, turn controls to the off
position, then remove plug from outlet.
12.Connect to properly grounded outlets only.
13.This appliance, when installed must be electrically
grounded in accordance with local codes, with the
current CSA C22.1 Canadian Electrical codes or for
USA installations, follow local codes and the
National Electric Code, ANSI/NFPA No. 70.
SAVE THESE INSTRUCTIONS
3
10006943
Stove Dimensions
A
E
F
C
B
D
A
B
C
D
E
F
Width of Stove Top
Width at Legs
24”
24”
15”
610 mm
610 mm
381 mm
410 mm
381 mm
660 mm
Depth at Legs
Depth at Handle
Depth at Stove Top
Total Height
16¹⁄₈”
15”
26”
4
10006943
Clearance to Combustibles
Grounding Instructions
Back . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2” (51 mm)
Sides . . . . . . . . . . . . . . . . . . . . . . . . . . . .6” (153 mm)
Floor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0” (0 mm)
Top . . . . . . . . . . . . . . . . . . . . . . . . . . . .24” (610 mm)
This heater is for use on 120 volts. The cord has a
plug as shown at A in Figure 1. An adapter as shown
at C is available for connecting three-blade grounding-
type plugs to two-slot receptacles. The green ground-
ing lug extending from the adapter must be connected
to a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a three-
slot grounded receptacle is available.
Hearth
A hearth is not mandatory, but is recommended for
aesthetic purposes. We recommend a noncombustible
hearth which does not obstruct heater openings.
Plexiglass Information
A
1. This product uses plexiglass on the door window.
2. Under no circumstances should this product be
operated with missing or broken plexiglass.
3. Do not strike or slam the plexiglass.
4. Do not use abrasive cleaners to clean the plexi-
glass.
Cover of
Electric Specifications
Grounded
Outlet Box
Grounding Pin
B
Voltage . . . . . . . . . . . . . . . . . . . . . . . .120V AC/60Hz
Total Amps . . . . . . . . . . . . . . . . . . . . . . .12.20 Amps
Total Watts . . . . . . . . . . . . . . . . . . . . . . . .1460 Watts
Heater Ratings . . . . . . . . . . . . . . . . . . . .1300 Watts
C
Metal Screw
Adapter
Electrical Connection
Grounding Means
A 15 Amp, 120 Volt, 60 Hz circuit with a properly
grounded outlet is required. Preferably, the appliance
will be on a dedicated circuit as other appliances on
the same circuit may cause the circuit breaker to trip
or the fuse to blow when the heater is in operation.
Fig. 1 Grounding methods.
The unit comes standard with a 6’ (1.8m) long three
wire cord, exiting from the rear of the stove. Plan the
installation to avoid the use of an extension cord. If an
extension cord must be used, it must be a minimum
14AWG, three wire with grounding type plug connector
and rated not less than 1875 Watts. The cord shall not
be more than 20’ (6m) in length.
WARNING: Electrical outlet wiring must
comply with local building codes and
other applicable regulations to reduce the
risk of fire, electrical shock and injury to
persons.
WARNING: Do not use this stove if any
part of it has been under water.
Immediately call a qualified service tech-
nician to inspect the stove and replace
any part of the electrical system.
5
10006943
Service Instructions
WARNING: Disconnect power before
Replacing Light Bulbs
attempting any maintenance or cleaning
to reduce the risk of fire, electrical shock
or personal injury.
This stove uses two clear 120 Volt, 40 Watt, E-12
socket base light bulbs (small base, chandelier candle
type). The 40 Watt bulbs are located under the log
set/ember bed. For convenience, if one of the bulbs
burns out, it may be a good idea to replace both of the
light bulbs.
Maintenance of Motors
The motors used on the fan and the flame generator
assembly are prelubricated for extended bearing life
and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater unit is recom-
mended.
1. Turn off power to the unit by unplugging the power
cord.
2. Let stove cool if it has been operating.
WARNING: Make sure the power is turned
off before proceeding.
3. Remove the access plate on the back of the stove
by removing the screws. You should have a clear
view of the light bulbs. Put your hand over the silver
flame generator to remove or replace the light
bulb(s).
CAUTION: Be careful not to touch or bend the flame
generator.
4. Examine the bulbs to determine which bulb needs
to be replaced.
5. Unscrew defective bulb(s).
6. Install new 40 Watt light bulb(s).
7. Replace access plate. Plug power cord into wall
outlet.
WARNING: Do not exceed 40 watts per
bulb. Use of higher rated bulbs may result
in a fire, causing property damage or per-
sonal injury.
6
10006943
Electrical Wiring Diagram
Any electrical repairs or rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing, color coding
and securing locations must be followed.
Switch
Thermostat
Black
LI
N
White
Black
Blue
Fan
Motor
Temperature
Limiting
Control
Blue
Motor
Heater
Assembly
White
Light Bulbs
White
Three Wire
Plug
Operating Instructions
Main On/Off Switch
Heater Control
The On/Off switch supplies power
to all of the functions of the stove.
It is located behind the front door.
The heater control acts to turn
the heater on and off as well
as setting the comfort level in
the room. Turning the knob
clockwise from the off position
will place the heater into oper-
ation. The further the knob is
rotated clockwise, the higher
the set point temperature.
ON/OFF
Switch
Temperature
Control
WARNING: During any service
of this appliance, the power to
the unit must be turned off. It is
not acceptable to use the
“On/Off” switch to meet this
requirement.
turning the knob counterclock-
wise will lower the set point
temperature. Turning it all the
way counterclockwise will turn
the heater function off.
7
10006943
1 YEAR WARRANTY
For HES60 Electric Stove
BASIC WARRANTY:
This warranty is void if:
CFM Corporation (hereinafter referred to collectively as
the "Company") warrants that your new Century stove is
free from manufacturing and material defects for a peri-
od of one year from date of installation, subject to the
following conditions and limitations.
a) The stove has been operated in atmospheres
contaminated by chlorine, fluorine or other damaging
chemicals.
b) The stove is subjected to prolonged periods of
dampness or condensation.
1. This electric stove must be installed and operated at all
times in accordance with the Installation and Operating
instructions furnished with the product. Any alteration,
willful abuse, accident, or misuse of the product shall
nullify this warranty.
c) Any alteration, willful abuse, accident, or misuse of
the product.
IF WARRANTY SERVICE IS NEEDED . . .
1) Contact your supplier. Make sure you have your
warranty, your sales receipt, and the model/serial number
of your CFM Corporation product.
2. This warranty is non-transferrable, and is made to the
original owner, provided that the purchase was made
through an authorized supplier of the Company.
2) DO NOT ATTEMPT TO DO ANY SERVICE WORK
YOURSELF.
3. This warranty is limited to the repair or replacement of
part(s) found to be defective in material or workmanship,
provided that such part(s) have been subjected to normal
conditions of use and service, after said defect is con-
firmed by the Company's inspection.
4. This warranty does not cover the lightbulb(s)
included with the stove.
5. The Company may, at its discretion, fully discharge all
obligations with respect to this warranty by refunding the
wholesale price of the defective part(s).
6. Any installation, labour, construction, transportation, or
other related costs/expenses arising from defective
part(s), repair, replacement, or otherwise of same, will not
be covered by this warranty, nor shall the Company
assume responsibility for same. Further, the Company
will not be responsible for any incidental, indirect, or
consequential damages, except as provided by law.
7. All other warranties - expressed or implied - with respect
to the product, its components and accessories, or any
obligations/liabilities on the part of the Company are
hereby expressly excluded.
8. The Company neither assumes, nor authorizes any third
party to assume, on its behalf, any other liabilities with
respect to the sale of this Norther Flame product.
9. The warranties as outlined within this document do not
apply to non-CFM Corporation accessories used in con-
junction with the installation of this product.
CFM Corporation
2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3
8
10006943
|